![]() ![]() ![]() It will figure out that a subwoofer is connected, route all the bass to it, and route everything else to the speakers you already have connected to the receiver. Go through "AUTO SETUP" procedure with your receiver using its "optimizer mic". Use an RCA to 3.5mm cable, or adapters to achieve same effect. Run a cable from receiver's "SUBWOOFER" output (in "PRE OUT" section) to the green input on the subwoofer. Hook up HK satellite speakers to HK sub so that sub will play. This will look a little ugly, but it should work fine. Thus there will be no material for the HK satellite speakers to produce, so they should stay silent even though they are hooked up. The crossover function will make sure that the receiver only sends low bass frequencies out on its subwoofer output. It says, "If your subwoofer can adjust the output volume and the crossover frequency, set the volume to about half way (or slightly less) and set the crossover frequency to the maximum." Looking at the manual, it appears that the receiver includes a DSP with room correction and crossover function (see pp. Then hook the whole system up to the subwoofer port on the receiver. If so, the most practical way to achieve that is to just leave the HK satellite speakers hooked up to the subwoofer. View online or download Harman kardon HK-595 User Manual. You have the HK satellite speakers, and you just don't want them competing with your regular speakers, correct?
0 Comments
Leave a Reply. |